Installation Guidelines Part 2

While OMEGA SHIELDING PRODUCTS offer the finest performance alternatives available today, there are a few simple guidelines to assure proper operation and continued long-term shielding effectiveness.

STORAGE
Shielding strips containing a transfer adhesive should be stored at a temperature of 70°F or lower.

INSTALLATION
Shielding strips should only be applied to a smooth, clean and dry mounting surfaces at room temperature (65° to 75°F). 1-2-3 Installation:

  1. Smooth the mounting surface with an emery cloth, if necessary, and clean with a suitable commercial solvent to remove all oils or film. Avoid fingerprints on the mounting surface after cleaning.
  2. Peel off the protective paper backing and avoid finger contact with the adhesive.
  3. Make certain that the strip is in the correct position and then press down firmly to insure a good bond over the entire mounting surface. Avoid any re-positioning after the strip is in place, for this will reduce the effectiveness of the adhesive and may distort the strip. Allow 24 hours for complete "curing" time.

Find a Product